EN
ES
FR
IT
NL
DE
www.petsafe.net 17
16 www.petsafe.net
Apply duct tape along top interior and exterior edge of cut-out. Leave approximately 5 cm uncovered on each
side and make sure no excess tape will show outside the frame. This is to cover raw edge of cut-out to keep it
from pinching or cutting Motion Sensor Wire (
fig. 4C
).
Place Exterior Frame into cut-out from the exterior of the door (
fig. 4D
).
Align Exterior Frame flush with bottom of cut-out (
fig. 4e
).
Helpful tip:
A spare pair of hands are useful at this point to hold Exterior Frame in place while you install
Interior Frame.
Plug Motion Sensor Wire from Interior Frame into connector on the Exterior Frame (
fig. 4f
).
Without pinching the wire, guide excess wire into space between top edge of door cut-out and tunnel on
Exterior Frame. Align Interior Frame into cut-out. View both sides of door to ensure the exterior and interior
telescoping tunnels are aligned (
fig. 4G
).
Helpful tip:
You should be able to see clearly through all screw holes when your door is aligned properly.
Step 5
Insert Screws and plugs
Insert mounting screws through Interior Frame screw holes. Be sure to insert screws into screw holes
inside Battery Compartment. Check to make sure Cat Flap fit is correct and frame is aligned flush.
Tighten screws (
fig. 5a
).
note:
This model of the Passport
™
Intelligent Cat Flap has 4 screw holes.
Insert finishing plugs into screw holes of Interior and Exterior Frames. Align flat edge of plugs with
outer edges of frame. Plugs will only fit into frame
in one direction (
fig. 5B
).
optional:
Apply silicone adhesive around
Exterior Frame for improved weather resistance.
Plug Power Adaptor into connector on underside
of Interior Frame (
fig. 5C
).
Route Power Adaptor wire through wire guides
in desired direction towards nearest mains power
outlet (
fig. 5D
).
4E
4D
4C
4G
4F
5A
5B
Optional
notICe
Use a manual screwdriver to tighten screws. Do not over-tighten. Over-
tightening can strip the screws or warp the Cat Flap frame.
5C
5D
