6
Customer Care Center 1-800-732-2677
Installation Instructions
Determine Pet Door Location
1A Measure and mark your pet’s shoulder height on the
interior side of door.
1B Determine location for the pet door. Draw a vertical
center line through the shoulder height line using a
level.
Prepare Door
2A Remove door by removing door hinge pins.
2B Place on a raised level surface such as saw
horses. Place interior side of door facing up.
Helpful Tip:
Clamp down the door to prevent it
from moving.
Note:
The Pet Door can be installed with the door
hanging based on your skill level.
2C Cut out the correct size template. Match the
marked lines on the door with the shoulder and
center lines on the template. Tape the template in
place and carefully trace template. Make sure to
trace underneath tape and connect the corners.
Now, remove the template and any excess tape
from the door.
NOTICE
If painting the pet door, it is recommended to paint it prior to installation.
For best results, use a primer for plastics before applying paint.
1A
1B
Step
1
NOTICE
If homeowner’s door or other application is
not level, the pet door must be marked level to
swing properly.
Step
2
NOTICE
When applying cutting template there should be a
minimum of 3” (76 mm) between the bottom and
sides of the door and the outer edge of the cutting
template to maintain the structural integrity of
the door.
NOTICE
Cut out correct size template. For the Large, no
cutting is required. If installing in a wall, reduce
cut-out width by 1” (25 mm) for the Small and
Medium. For the Large reduce cut-out width by 1”
(25 mm) and cut-out height by 1” (25 mm).
2A
2B
2C
Summary of Contents for HPA11-10987
Page 35: ...petsafe com 35 ...
