petsafe.com 5
NOTICE
If painting the pet door, it is recommended to paint it prior to installation.
For best results, use a primer for plastics before applying paint.
Step
1
Step
2
Determine Pet Door Location
1A
1B
1A Measure and mark your pet’s shoulder height on
the interior side of door.
1B Determine location for the pet door. Draw a vertical
center line through the shoulder height line using
a level.
NOTICE
If homeowner’s door or other application is
not level, the pet door must be marked level to
swing properly.
Prepare Door
2A
2B
2C
2A Remove door by removing door hinge pins.
2B Place on a raised level surface such as saw horses.
Place interior side of door facing up.
Helpful Tip:
Clamp down the door to prevent it
from moving.
Note:
The Pet Door can be installed with the door
hanging based on your skill level.
2C Cut out the correct size template. Match the
marked lines on the door with the shoulder and center
lines on the template. Tape the template in place and
carefully trace template. Make sure to trace under-
neath tape and connect the corners. Now, remove the
template and any excess tape from the door.
NOTICE
When applying cutting template there should be a
minimum of 3” between the bottom and sides of the
door and the outer edge of the cutting template to
maintain the structural integrity of the door.
NOTICE
Cut out correct size template. For the Large, no
cutting is required. If installing in a wall, reduce cut-
out width by 1” for the Small and Medium. For the
Large reduce cut-out width by 1” and cut-out height
by 1”.
Installation Instructions