Petsafe Comfort-Fit System, Operating And Training Manual

Page: 9 / 24

www.petsafe.net 9
Prepare the Receiver Collar
To Insert and Remove the Battery
Note: Do not install the battery while the Receiver Collar is on your pet.
This Receiver Collar utilizes a replaceable PetSafe ® battery
(RFA-188). This unique battery is designed to make battery
replacement easier and increase water protection.
To activate the collar, insert the battery module ( 5A ). Using the
edge of the Test Light Tool as shown, turn the battery clockwise
until the vertical line on the battery is pointed to the “ON”
position (
5B ). If the PetSafe ® Receiver Collar is not going to be
used on the pet immediately, leave it in the “OFF” position.
To remove the battery, turn the battery counter-clockwise using
the edge of the Test Light Tool as shown (
5C, 5D ). DO NOT
attempt to cut into or pry open the battery. Be sure to discard the
used battery properly.
A replacement PetSafe ® battery can be found at many retailers.
Contact the Customer Care Center at 1-800-732-2677 or visit
our website at www.petsafe.net to locate a retailer near you.
5A 5B
5D
5C
Two Color LED
The two color LED indicator shows good or low battery. Good battery equals 1 fl ash every 60 seconds with Green LED.
Low battery equals 3 fl ashes every 60 seconds with the Red LED. If there are no LED lights it is time to change the battery.
To Set the Static Correction Level
Read all steps before attempting to set the Static Correction Level.
1. With the battery installed, press the Correction Level Button and release when the
Receiver Indicator Light lights red ( 5E ).
2. The Receiver Indicator Light will emit a number of red fl ashes representing the Static
Correction Level ( 5F ).
3. Increase the Static Correction Level by pressing and releasing the Correction Level
Button within 5 seconds of the previous fl ashes.
The Static Correction Levels increase from 1 to 5. Pushing the Correction Level Button
while the Receiver Collar is on level 5 will cause the Receiver Collar to revert to level 1.
Refer to the Function and Response Table to choose the Static Correction level that best
fi ts your pet.
5E
5F
The Receiver Collar is equipped to automatically increase the level of Static Correction the longer your pet remains
in the Static Correction Zone if the collar is set at level 2 or above.
The Receiver Indicator Light acts as a low battery indicator, fl ashing every 60 seconds when battery replacement is
required.
Function and Response Table
Note: Begin training with Static Correction Level 2 and only increase if your pet does not respond to the Static Correction.
Indicator Light Response Static Correction Level Receiver Collar Function Temperament of Pet
1 Red Flash 1 No Static Correction, Tone Only
2 Red Flashes 2 Low Static Correction Timid
3 Red Flashes 3 Medium Static Correction Timid or Average
4 Red Flashes 4 Medium High Static Correction Average or High Energy
5 Red Flashes 5 High Static Correction High Energy
Flashes 3 Red Flashes
every 60 seconds Low Battery
Step
5