43
It is suggested to use the fixed wheels on particularly uneven
grounds. The wheels in swivel mode instead, can be used to improve
the stroller’s handling on regular road surfaces. To lock the front swivel wheels, press
down the locking button on the front yoke. To release the locking device
of the front fixed wheels, press again the locking button with your foot. Regardless
of the position in which the wheel is located, they will lock in straight position. Fig 5.
WARNING:
Both wheels must always be locked or released to swivel
at the same time.
WARNING:
Before using the stroller, make sure that the wheels are well secured
to the structure.
ASSEMBLY OF THE SEAT: STROLLER CONFIGURATION
6. Put the seat into the corresponding holes on the construction of a stroller,
as shown in Figure 6, you should hear a click fuses.
WARNING:
Make sure the seat is installed properly by pulling it upward.
WARNING:
The seat can be placed on the chassis only so that the child
is seated in the driving direction.
If you want to remove the seat, press two fuses located on both of the sides
of the joint at the bottom of the seat and pull the seat up. These actions do not
make when a baby is in the seat.
WARNING:
Do not remove the seat from the stroller when the child is inside of it.
CANOPY
7. A canopy can be installed on the stroller.
The seat features two joints positioned on the sides of the backrest that allow
the securing of the canopy.
To secure the canopy, introduce the fastening system into the joints as shown
in Fig 7.
Then, secure the fabric part to the canopy using the zip located on the seat frame,
around the backrest.
WARNING:
The canopy must be anchored to both sides of the stroller. Make sure
it is secured properly. Fig 7 a Fig 7.1
Oversize zippered canopy extension offers full coverage keeping your child
protected.
To remove the canopy, open the zip of the canopy’s fabric part completely
and press the buttons located inside the canopy’s joints then pull the canopy
upward. To adjust the canopy, pull and/or push it centrally, Fig 7.1.
REMOVABLE BUMPER BAR
8. The stroller is equipped with removable bumper bar.
To fix the bumper bar, insert it into holes on the construction, as shown in Fig 8,
you should here the click.
EN
Summary of Contents for Grand II
