Troubleshooting
My pet does not respond after correct installation Petrainer Rechargeable
and Waterproof Training Collar, or it does not work?
You need charge Remote Transmitter and Receiver Collar for 6 hours
individually first.
You need to turn on the Remote Transmitter By holding the Mode botton
for 5 seconds.
Check the levels of vibration or static shock.
Make sure the Receiver Collar has enough power to operate.
Restart the Receiver collar by pressing the on/off button.
Test 4 functions (Beep, Light, Vibration and Shock) first before using. See
part "Test" of Operation Guide.
Intensity level has to be more than "0" when encode, test to launch for
Vibration and Staic Shock Function.
The Receiver collar will go into deeply sleep if no operation for 5 minutes.
And any movement will activate it.
Make sure the Contact Points are placed snugly against your pet's skin.
Trim your pet's fur where the Contact Points touch the neck and/or switch
to the longer Contact Points.
If all of above does not work, you can try reencode between Remote
Transmitter and Receive Collar. (See part "Encode" of Operation Guide)
Remote Transmitter does not work
You need charge Remote Transmitter for 6 hours when you get product
first time.
Check if Remote Transmitter is on low battery status, the symbol ft will
show up on the right down side of LCD screen.
You need to hold the Remote Transmitter for 5 seconds for turning on it.
Remote Transmitter will automatically goes into standby mode if no action
is detected with 2 minutes, at this time there will be no LCD display. Press
any button except LED light button to re-activate the Remote Transmitter.
16
Remote Transmitter will automatically goes into deeply sleep status if no
action is detected within 5 minutes, at this time there will be no LCD
display. You have to press "Mode" button for 5 seconds until LCD display.
My Receiver Collar works great for some time, but it does not work
anymore after I charged.
First, check if charging is successful, when you are charging, red LED light
will be on, after fully charged, the red led light will be turned to green LED
light automaically.
You have to turn on Receiver Collar again after you charged
We turned on the receiver collar and it starts to beep for 20 seconds.
Receiver Collar will beep for 20 seconds in Low battery status unless it
gets charged, charge it for 6 hours and the other functions will work after
charging finished.
I want to test Receiver Collar myself, but it does not work.
If you test Receiver Collar by your hand or leg, please touch the 2 electrodes
at the same time, only touch one electrodes will not work.
The Receiver Collar is in bad quality, it didn't work after knocking down
Our Receiver Collar is designed to be not knock-down, please don't knock
down it avoiding breaking structure and circuit.
Find the Best Intensity Level for Your Pet
General Tips
Eliminate one misbehavior or teach one obedience command at a time. If you
move too fast with the training, your pet may become confused.
Be consistent. Give your pet a tone or stimulation with each misbehavior.
Do not over-correct your pet. Use as few stimulations as possible to train your pet.
Unless you can supervise him, it is recommend that you restrict your pet from
situations in which he has a history of misbehaving. However, setting up a
situation as a training session can dramatically improve your chances of success.
If your pet reacts to the training by hiding or acting fearful, redirect his attention
to a simple and appropriate behavior such as the "Sit" commend.
17
