~ 6 ~
TROUBLESHOOTING
A. If you cannot get the audio/video output from the connected display from the first time setup.
Please follow the instructions below to check if the extender is OK:
Step 1 – Set the rotary arrow on the TX unit at
Mode 5
for Safe Mode, and wait for the
RJ45’s LED blinking for a couple seconds.
Step 2 – Dial the rotary arrow counterclockwise [ ] from
Mode 5
to
Mode 3
. If you can get
audio/video from the display, you can stay tune at this setting for 1080p and stereo
audio. If you need to get 1080p and 7.1ch audio output, dial the rotary arrow
counterclockwise [ ] from
Mode 3
to
Mode 2
. If you cannot get the audio/video
out normally, please do EDID learning sequence stated in EDID LEARNING
section.
B. For desirable 1080p video output, please follow the instructions below:
Step 1 – Set the rotary arrow on the TX unit at
Mode 6
for Default Mode, and wait for the
RJ45’s LED blinking for a couple seconds.
Step 2 – Dial the rotary arrow clockwise [
] from
Mode 6
to
Mode 1
. If you can get
audio/video from the display, you can stay tune at this setting for 1080p and stereo
audio. If you need to get 1080p with 7.1ch audio output, dial the rotary arrow
counterclockwise [ ] from
Mode 1
to
Mode 0
. If you cannot get the audio/video
out normally, please refer to EDID LEARNING section to learn the EDID from this
intended HDMI display for PRO-HDMI-CAT-PLG-TX.
