12
8.
Sensor check
You can easily check the sensor readings by disconnecting the motor. When Perun V2 Hybrid is
connected to the battery, but disconnected from the motor, it informs about this by yellow, flashing
light. If during that flashing a properly working and connected switch will be closed, the unit will signal
that by changing the LED color for a moment.
Attention!
To enter this mode, the motor must be disconnected first, only then connect the battery!
Attention!
After you enter the sensor check mode, it will be active for 5 minutes, after which the unit
will shut down. To restart it, simply reconnect the battery.
LED color
Switch
Disconnected motor / Sensor
check
Yellow, blinking
None of the sensors detects any change at this moment.
Selector switched to “AUTO”
Red
This should happen after the selector is switched
to “AUTO”.
Selector switched to “SEMI”
Blue
This should happen after the selector is switched
to “SEMI”.
Selector switched to “SAFE”
White
This should happen after the selector is switched
to “SAFE”.
Trigger
Purple
Trigger pull detected.
Sector gear
Green
Sector gear movement detected.
Checking the trigger and selector sensor can be done by simply pulling the trigger or switching the
selector between
“SAFE”,
“SEMI” and “AUTO” positions. This can be done without disassembl
ing the
whole replica.
To check the sector gear sensor, it is best to open the gearbox and remove everything out of it, except
for Perun and the sector gear (make sure to keep the shimming the same as in assembled replica, it
can influence whether the sensor would work or not). Then spin the sector gear by hand and see,
whether the color of the light changes to green.
