13.2) Permanent manual forcing
During normal operation or temporary manual forcing conditions,
is obtained by pressing
Permanent forcing status is highlighted on the display by the appearance of the message
During
, all
programs are inhibited (suspended). It is possible to change permanent channel (from
to
and vice-versa) by briefly
pressing key
. To return to normal programming operations, press key
. The channel will return to normal
programming at the end of the current minute.
channel permanent manual forcing
key
.
permanent forcing
On
OFF
for 5 seconds.
for 5 seconds
1
1
1
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1
5 SEC
1
1 2 3 4 5 6 7
1
5 SEC
In normal operation, if you wish to
the entire time switch, simultaneously press
and
and
After having performed the lamp-test cycle, the device will be ready for current hour entry.
fully reprogram
keep pressed
for 3 seconds.
OK
PROG
14 - DELETING ALL ENTERED DATA
Reset operations reset the time switch and are used for example upon initial start-up or if any anoma-
lies or malfunctions should be noted.
Lightly press
with a sharp object. After a lamp-test, settings relative to current hour and day will
be set to zero (weekly model only).
RESET
All operating programs shall remain saved in the permanent memory of the device.
see paragraph 5.2
This same conditions occurs if the device is without power for a period exceeding the internal accumu-
lator charging reserve. Re-enter the current hour and day, for reprogramming
; oth-
erwise, time switch will not execute programs.
This operation deletes all data saved in the time
switch, returning it to default conditions.
To fully reprogram the device, see paragraph 5.2.
15 - RESET OPERATION OR RESET WITH ACCUMULATOR DISCHARGED
Ok
Prog
Delete
1 2 3 4 5 6 7
1 2 3 4 5 6 7
3 sec.
1 2 3 4 5 6 7
27
EN
1 2 3 4 5 6 7
Day
Ok
Prog
1
Delete
Summary of Contents for 1IO 6081
Page 68: ......
