INSTALLATION INSTRUCTIONS
PROBLEM
POSSIBLE CAUSE
WHAT TO DO
Water and Steam is spitting
from the instant hot water
Dispenser spout
Unit is boiling
Turn instant hot water Dis-
penser handle on and release at
least 1 pint of water.
Adjust the water temperature
on the display to a lower
setting.
Check aerator is not blocked
Bleed system to remove any air
Re-Prime bladder to allow cor-
rect operation.
Water is not hot.
The electronic instant hot
water appliance is un-
plugged.
The electronic display has
not been powered up
Make sure the electronic instant
hot water appliance is plugged
in and connected to a grounded
electric outlet
Make sure that the circuit
breaker and fuse are working
correctly
Turn on the power and touch
the on / off button and then set
the required temperature and
confirm the heat up.
Water is too hot.
Water temperature
setting on display panel is
set to high.
Re-set the temperature to the
required temperature and con-
firm the heating up
Water is dripping from the
instant hot water Dispenser
spout.
The expansion chamber
isn't draining the system
correctly due to very
small draw off of water
The spout is blocked
Draw off 1 pint of water to clear
and prime the system. Avoid less
than 1/3 of a pint draw offs of wa-
ter. Remove and clean the aerator.
Check silicon pipe length.
TROUBLE SHOOTING
Consult your local House of Rohl showroom for additional information and specifications. For complete warranty details and a list of showrooms, go to houseofrohl.com
houseofrohl.com
