Permobil X850 MiniFlex, Owner'S Manual

Page: 118 / 128

Owner's Manual Permobil X850 MiniFlex Troubleshooting
Troubleshooting guide
The following troubleshooting guide describes a number of faults and events which may occur when you use your
wheelchair, together with suggested remedies. Note that this guide cannot describe all the problems and events which
may occur and you should always contact your service contact or Permobil in case of doubt.
EVENT POSSIBLE CAUSE REMEDY
Wheelchair cannot be started. Batteries discharged. Charge the batteries.
Main fuse switched to OFF position after, for
example, battery replacement. Reset the main fuse. See page 107.
Main fuse triggered. See page 107.
Wheelchair cannot be driven. Battery charger connected. Stop charging and disconnect the charging
cable from the wheelchair’s charging socket.
Brake release activated. Reset the brake release.
Wheelchair locked with the security key. Unlock the wheelchair.
Battery voltage indicator on the control panel
flashes at 2.5 second intervals and the wheel-
chair cannot be driven.
Electronics’ power saving position is
activated. Switch off and switch on the power using the
start key on the control panel.
Battery voltage indicator on the control panel
flashes quickly and the wheelchair cannot be
driven.
Electronics fault. Contact service.
Wheelchair stops while being driven. Main fuse triggered. See page 107.
Wheelchair can only be driven at reduced
speed.
Applies to wheelchairs with an electric
seat lift.
Seat lift or seat angle raised too high. Lower the seat lift.
118