6
ROHO AGILITY Minimum/Mid Contour Back Support Operation Manual
Cover Components Installation
Warning:
The air insert and the foam insert are not intended to be used
together.
Warning:
DO NOT install or remove AGILITY cover or components while
the individual is in the wheelchair.
To Install the Foam Pad (for foam-only models)
1. Unzip the cover and place the foam pad into the cover.
Note: The wide and narrow ends of the foam pad should be aligned with the wide and narrow ends of the cover.
2. Zip the cover closed.
3. Install the cover on the back shell. See "Cover Removal and Installation".
To Install the Foam Pad with the Air Insert
1. Slide the valve hose through the hole in the foam pad. The air cells should
face out.
2. Tuck the edges of the air insert under all of the edges of the cutout area.
Press to secure the air insert to the fastener strip in the cutout area.
3. Unzip the cover. Place the foam pad and air insert into the cover. The air
insert should face the front of the cover. The wide and narrow ends of the
foam pad should be aligned with the wide and narrow ends of the cover.
4. To complete installation of the cover on the back shell, follow the
instructions below: "Option A" or "Option B".
Air insert with valve hose
Foam Pad
Cutout area with fastener strip
Installing the Cover on the Back Shell - Valve Hose Placement
Option A:
If no air insert adjustment is needed
after the cover is installed on the
back shell:
a. Place the valve hose inside the
zipper. Zip the cover closed.
b. Install the cover on the back
shell. See "Cover Removal and
Installation".
Option B:
If the air insert will need to be
adjusted after installing the
AGILITY on the wheelchair:
a. Partially zip the cover closed,
allowing access to the inflation
valve.
b. Install the cover on the back
shell. See "To Adjust the Air
Insert".
To Install the Foam Pad with the Foam Insert
1. Align the foam insert with the cutout area. Press to secure the fastener strips.
2. Unzip the cover and place the foam pad with the foam insert attached into the cover.
Note: The side of the foam pad with the foam insert should face the front of the cover. The wide and
narrow ends of the foam pad should be aligned with the wide and narrow ends of the cover.
3. Zip the cover closed.
4. Install the cover on the back shell. See "Cover Removal and Installation".
Foam Insert
Foam Pad
Cutout area with fastener strip
