6
ROHO AGILITY Max Contour Back Support Operation Manual
Cover Components Installation
Warning:
The air insert and the foam insert are not intended to be
used together.
Warning:
DO NOT install or remove AGILITY cover or components while the
individual is in the wheelchair.
To Install the Foam Pad with Air Inserts
1. Slide the valve hose through the hole in the foam pad. The air cells
should face out.
2. For each air insert,
tuck the edges of the air insert under all of the edges of the
cutout area. Press to secure the air insert to the fastener strip in the cutout area.
3. Unzip
the cover. Place the foam pad and the air inserts into the cover.
-
The air
inserts
should face the front of the cover.
-
The wide and narrow ends of the foam pad should be aligned with the wide
and narrow ends of the cover.
4. To complete installation of the cover on the back shell, follow the instructions
below: "Option A" or "Option B" and "Wing Air Inserts".
Foam pad
Cutout area with
fastener strip (x3)
Air insert with
valve hose (x3)
Installing the Cover on the Back Shell - Valve Hose Placement
Air Insert - Option A:
If no air insert adjustment
is needed after the cover is
installed on the back shell:
a. Place the valve hose
inside the zipper.
b. Zip the cover closed.
c. Install the cover on the
back shell.
d. See "Cover Removal
and Installation".
Air Insert - Option B:
If the air insert will need to be adjusted after
installing the AGILITY on the wheelchair:
a. Leave the zipper partially open.
b. The valve hose for the air insert should
be routed down the INSIDE of the back
shell, and then around the bottom of the
back shell, so that it is accessible on
the OUTSIDE of the back shell.
c. Tuck the valve hose into the side
pocket.
d. Install the cover on the back shell. See
"Cover Removal and Installation".
Wing air inserts:
Tuck the valve
hoses into the side
pockets, as shown.
To Install the Foam Pad with Foam Inserts
1. Align the foam inserts with the cutout areas. Press to secure the fastener
strips.
2. Unzip the cover and place the foam pad, with the foam inserts attached,
into the cover.
Note: The side of the foam pad with the foam inserts should face the
front of the cover. The wide and narrow ends of the foam pad should be
aligned with the wide and narrow ends of the cover.
3. Zip the cover closed.
4. Install the cover on the back shell. See "Cover Removal and Installation".
Foam insert (x3)
Foam pad
Cutout area with fastener strip (x3)
