Permobil Chairman 2k, Service Manual

Page: 31 / 40

31
Fuses & circuit breaker
Fig. 70. The SLS Drive sits in its container
without fastening screws.
Replacement of charging fuse
The charging fuse is located at the front edge of
the left front fender, under the charging outlet, see
fig. 69. Switch off the main power switch on the
control panel and disconnect the charger before
replacement of the charging fuse is performed.
NB! In order for the charging to function, the circuit
breaker must also be set in the “ON” position.
Fuse replacement for seat/lighting
On the SLS Drive, there are two fuses:
F1 (24V unswitched) and F2 (24V switched).
These provide fuse protection for two power
outlets which are located to the left on the SLS
Drive, beside the charging outlet. One of the
outlets (24V unswitched) supplies power
regardless of whether the chair is switched off or
on. The other outlet (24V switched) supplies power
only when the chair is switched on. The seat and
lighting are normally connected to this outlet.
1. Switch off the main switch on the control panel.
2. Put the circuit breaker in the “OFF” position,
see fig. 66.
3. Remove the seat lift and chassis covers,
see page 8.
4. Lift the SLS Drive out of its holder, see fig. 70:1.
5. Pull the lid off the SLS drive stage.
6. Change the blown fuse.
7. Place the lid back onto the case.
8. Remount the SLS Drive into its holder.
NB! Make sure that no cables are to be found in
the area under the seat lift by the seat lift's drive
belt, see fig. 70:2.
9. Remount the covers, see page 8.
F1 F2
Fig. 71. F1 = 24V uninterrupted 15A.
F2 = 24V interrupted 15A Seat/Lighting.
Fig. 69. Charging fuse 15A.
1
2