Perle SR-100 Fast Ethernet Media Converter Installation Guide 11
Installing the SFP Fiber Module
The SR-100-SFP requires an SFP fiber module.
1. Locate your fiber module, and then insert the module into the
transceiver opening.
2. Ensure the SFP module is properly seated.
3. The SFP module may be inserted before or after applying
power to the media converter.
4. Proceed with cable connections.
Installing the Duplex Fiber Cable
•
Locate a 100Base-X compliant duplex (2 strands) fiber cable
with male connections.
•
Connect the fiber cables from one media converter to the other
media converter/switch/fiber device ensuring that the RX and TX
are reversed at the opposite end.
Installing the Simplex Fiber Cable
Locate a 100Base-X compliant simplex (1 strand) fiber cable with
male connections.
•
Connect the fiber cable from one media converter to the other
media converter/switch/fiber device.
Installing the Copper Cable
•
Locate 100Base-TX compliant copper cables with male, RJ45
connectors installed at both ends.
•
Connect the RJ45 cable between the Perle media converter and
the device.
Note:
The Perle media converter supports Auto-MDI-X, either a
straight-through or cross over Ethernet cable may be used.
