IOLAN SDG2 W Quick Start Guide ‐ P/N 5500415‐10 (Rev C)
4
WLAN
Green solid
— A wireless connection has been established
Green pulsing
—Data is being transmitted over the wireless network
Off
—No wireless connection is established
Signal
Wireless signal strength from yellow LEDs to green LEDs with green being the
strongest signal strength.
Tx/Rx
Flashing
– Indicates transmit/receive serial activity
Connecting to the IOLAN via the Wi-Fi Network
The following steps allow for connection to the IOLAN for initial configuration.
Initial Setup – Using Soft‐AP Method
The IOLAN SDG2 W must be powered up.
Press the inset WPS button (using a paper clip) for 4 seconds to enable Soft‐
AP mode. The Signal strength LED display should show a pulsing green LED on
the third light from the left to right to confirm you are in Soft‐AP mode.
The IOLAN SDG2 W is listed on your network connections on your PC or
wireless client. It will appear as SSID: IOLAN‐xxxxxx (the last 6 digits of the
IOLAN wireless MAC address ‐ found on the product label).
Select this SSID on the PC.
When a password is requested, enter the password printed on the product
label.
You should now be connected to the IOLAN’s Wireless interface.
Use a Web browser to connect to the default address of the IOLAN SDG2 W
at (192.168.0.1).
The default userid is “admin” and the default password is “superuser” (case
sensitive).
You can now configure and manage your IOLAN SDG2 W using the IOLAN
WebManager application.
Note:
You should change the admin password to restrict unauthorized access to
your IOLAN.
For additional methods of configuring your IOLAN (i.e., Device Manager, Telnet,
SNMP), please refer to the IOLAN User’s Guide.
Registering
the IOLAN
You should register IOLAN online at:
www.perle.com/support_services/warranty_reg.asp
Contacting Technical Support
Contact information for the Perle Technical Assistance Center (PTAC) can be found
at the link below.
www.perle.com/support_services/support_request.shtm
