background image

IDS-205G Switches Quick Start Guide P/N 5500396-10  (Rev A)

                                      

                                      

 

Fast Setup 

Fast Setup provides a simple method of doing an initial setup from a PC. It only 
requires a PC Ethernet connection and a web browser. Other methods to configure the 
IDS Switch can be found in the IDS Switch User’s guide.

 

1.

 

Your PC must be set to obtain an IP address automatically using DHCP (See 
Control Panel ->Network and Sharing Center -> Change adapter settings ->Local 
Area Connection Properties ->Internet Protocol Version (TCP/IPv4) ->Properties 
->Select Obtain an IP address automatically. 

2.

 

Press and hold the reset button (5)on the switch for 4 seconds and then release it. 
Since the reset button is recessed in the switch, a small tool such as a paper clip 
will be required.  The yellow and green LEDs on an empty RJ-45 connectors will 
flash rapidly to indicate where to plug in the Ethernet cable from your PC.  

3.

 

Using a web browser, enter to a well known webpage such as www.google.com, 
you will be automatically directed to the IDS Get Started screen. 

 

Note:

 While in Fast setup mode the IDS switch will use an IP address of 169.254.0.1. If step 3 fails to 

direct the browser properly, then enter the switch’s IP address into the browser’s address bar

 

 

4.

 

 Fill in the required fields, apply changes to save and exit. The configuration 
changes will be immediately applied to the switch. 

5.

 

The PC can now be reset to its normal network address and the switch can now 
be accessed using the conventional IP addressing. 

 
 

©2016 Perle Systems Limited. All rights reserved. 

 

Summary of Contents for IDS-205G

Page 1: ...s intended for first time setup or for product evaluation purposes Complete details can be found in the following guides at www perle com downloads IDS 205G Hardware Installation Guide IDS Managed Switches User Guide IDS Managed Switches CLI Guide What s in the box The IDS switch Quick Start Guide this document Hardware Overview ...

Page 2: ... 7 8mm 5 16 3 Loosen the terminal block screws and connect positive negative wires in the terminals 4 Tighten terminal screws 0 51Nm torque Ensure the wires are securely fastened 5 Re insert the terminal block connector if removed Turn power on at source Check LED indicators for status 6 Connect P2 power source 2 beginning at Step 1 For complete wiring instructions and for all Hazardous Locations ...

Page 3: ...us Green blinking System booting Green solid System operating normally Green blinking fast Fast Setup mode activated Red Hardware fault or firmware load error 5 Port 5 Fiberport Link Activity Off Link down Green flashing Link and activity Green blinking slowly Port in error disable or suspend state Ethernet Port Link Speed Green and Yellow LEDs 1000 Mbps Green on Yellow off 100 Mbps Green on Yello...

Page 4: ...on is recessed in the switch a small tool such as a paper clip will be required The yellow and green LEDs on an empty RJ 45 connectors will flash rapidly to indicate where to plug in the Ethernet cable from your PC 3 Using a web browser enter to a well known webpage such as www google com you will be automatically directed to the IDS Get Started screen Note While in Fast setup mode the IDS switch ...

Reviews: