Perle 10G Media Converter module Installation Guide
6
Auto-Config Jumper (CM models only)
The Auto-Config jumper (J5) is located on the upper edge, at the
midpoint of the module.
Strapping pins 1 and 2 of the jumper will set the module in SW
mode and strapping pins 2 and 3 will set it in Auto-Config mode.
Auto: When set to Auto the module will, at power-up, check its
internal flash memory to see if configuration information has been
downloaded to it from a management module. If so it will use this
configuration as its running configuration. If there is no
configuration in flash it will read the settings of the DIP switches
and use those as its running configuration.
SW: When set to SW (Switch), the module will, at power-up, read
the settings of the DIP Switches and use those as its running
configuration. It will ignore any configuration information in its flash
memory.
NOTE: The default jumper setting is Auto
DIP Switch Settings
The DIP switches are located on the side of the module. The
function of the DIP switches vary by model, so please refer to the
appropriate model.
Note: Switch changes made when the product is powered up take
effect immediately and will result in a link reset on both ports.
