Perle 10G Media Converter module Installation Guide
7
DIP Switch Settings
The DIP switches are located on the side of the module. The
function of the DIP switches vary by model, so please refer to the
appropriate model.
Note:
Switch changes made when the product is powered up take
effect immediately and will result in a link reset on both ports.
Operating Mode (Switch 1)
Switch Position
Mode
Up (default)
Data
Down
Test
Data:
In Data mode, data will flow between the two fiber
connections.
Test:
Test Mode is used to run diagnostics, enable loopback and
for running the Built In Link Tests.
Note:
The Operation Mode (Switch 1) affects the function of DIP
Switches 2 and 3.
Link Mode (Switch 2
– Data Mode)
Switch Position
Mode
Up (default)
Smart Link Pass-Through Mode
Down
Standard Mode
Smart Link Pass-Through
: In this mode, the link state on one
connection is directly reflected through the Media Converter
module to the other connection. If fiber link is lost on one of the
connections, then the other fiber link will be brought down by the
Media Converter module
Standard Mode:
In this mode, the links can be brought up and
down independently of each other. A loss of link on either fiber
connection can occur without affecting the other fiber connection
