Note:
Ensure that fuel injection lines do not contact
any other engine component.
6.
Tighten bolt (32) to a torque of 25 N·m (221 lb in).
7.
Remove the caps from the port of the electronic
unit injector and from the appropriate port in fuel
manifold (16).
8.
Loosely connect the nuts at both ends of new fuel
injection line (12) to the electronic unit injector and
to the appropriate port in fuel manifold (16). Ensure
that the ends of the fuel injection line are correctly
seated in the electronic unit injector and in the fuel
manifold.
9.
Repeat Step 7 through Step 8 in order to install the
remaining new fuel injection lines.
10.
Position clamp (22) onto fuel injection lines (12)
and install clamp bolt (20). Tighten the bolt to a
torque of 10 N·m (89 lb in).
Note:
Ensure that the rubber separator is correctly
installed around the fuel injection lines. Ensure that
fuel injection lines do not contact any other engine
component.
11.
Repeat Step 10 for the remaining fuel injection
lines.
12.
Use Tooling (B) to tighten the nuts on fuel
injection line (12) to a torque of 25 N·m (221 lb in).
13.
Position bracket (25) onto the valve mechanism
cover. Install bolt (26) and tighten the bolt to a
torque of 10 N·m (89 lb in).
14.
If necessary, reinstall the front engine lifting eye
(31). Install bolts (30) and tighten the bolts to a
torque of 45 N·m (33 lb ft).
Illustration 26
g02849446
Illustration 27
g03774865
UENR4503
21
Disassembly and Assembly Section
