Illustration 31
g01239580
Typical example
2.
Remove nut (5) and bolt (4).
3.
Loosen nut (7) and push the alternator (6) toward
the engine.
4.
Remove the belt (1).
Installation of the Alternator Belt
1.
Install the belt (1) over the pulleys.
Note:
Ensure that the teeth on the belt are engaged
with the teeth on the pulleys.
2.
Pull the alternator (6) away from the engine. Install
bolt (4) and nut (5).
3.
Tighten nuts (5) and (7).
4.
Check the tension of the belt. Refer to “Inspection”
for the correct procedure.
5.
If necessary, restore the electrical supply to the
engine and install the guards.
i02894971
Carburetor Air/Fuel Ratio -
Check/Adjust
An engine failure may occur if the air/fuel ratio is not
appropriate for the fuel and for the operating
conditions. The service life of the turbocharger, of the
valves, and of the other components may be
reduced.
Refer to the Systems Operation, Testing and
Adjusting for the correct procedure.
i02450196
Control Panel - Inspect
Inspect the condition of the panel. If a component is
damaged, ensure that the component is repaired or
that the component is replaced. If equipped, ensure
that the electronic displays are operating properly.
Inspect the wiring for good condition. Ensure that the
wiring connections are secure.
Refer to the OEM for more information.
i09210533
Cooling System Coolant (ELC)
- Change
Refer to the OEM for information on cogeneration
engines.
Jacket Water System Drain
1.
Stop the engine and allow the engine to cool.
Loosen the cooling system filler cap slowly to
relieve any pressure. Remove the cooling system
filler cap.
2.
Open the drain cock or remove the drain plug on
the radiator or the heat exchanger.
Illustration 32
g01515804
Typical example
SEBU8430-02
55