Illustration 59
g01238304
Typical example
2.
Remove the guards (not shown) to gain access to
the fan drive pulley (1).
Illustration 60
g01238305
3.
Tighten the grub screws (2) to a torque of 90 N·m
(66 lb ft).
4.
Install the guards (not shown).
5.
Restore the electrical supply to the engine.
i03783899
Fuel
Injector
-
Inspect/Adjust
NOTICE
Only qualified service personnel should perform this
maintenance. Refer to the Service Manual or your au-
thorized Perkins distributor for the complete proce-
dure in order to inspect or adjust the fuel injectors.
Operation of Perkins engines with fuel injectors that
have not been inspected or adjusted can reduce en-
gine efficiency, and also reduce engine component
life.
Refer to Systems Operation, Testing and Adjusting,
“Fuel Injector Adjustment” for the correct procedures
to inspect and adjust the fuel injectors.
i06530425
Fuel System - Prime
If air enters the fuel system, the air must be purged
from the fuel system before the engine can be
started. Air can enter the fuel system when the
following events occur:
• The fuel day tank is empty or partially drained
• The low-pressure fuel lines are disconnected
• A leak exists in the low-pressure fuel system
• The fuel filter has been replaced
Use the following procedures to remove air from the
fuel system.
NOTICE
Do not crank the engine continuously for more than
30 seconds. Allow the starting motor to cool for two
minutes before cranking the engine again.
SEBU9077-01
69
