Illustration 78
g02351361
Typical example
3.
Clean sealing surface (2).
4.
Apply clean engine oil to O ring seal (3) for the new
oil filter.
NOTICE
Do not fill the oil filters with oil before installing them.
This oil would not be filtered and could be contami-
nated. Contaminated oil can cause accelerated wear
to engine components or engine damage.
5.
Install the new oil filter. Spin on the oil filter until the
O ring contacts the sealing surface (2). Then
rotate the oil filter ¾ of a full turn.
Fill the Oil Pan
1.
Remove the oil filler cap. Refer to this Operation
and Maintenance Manual, “Fluid
Recommendations” for more information on
suitable oils. Fill the oil pan with the correct
amount of new engine lubricating oil. Refer to this
Operation and Maintenance Manual, “Refill
Capacities” for more information on refill
capacities.
NOTICE
If equipped with an auxiliary oil filter system or a re-
mote filter system, follow the OEM or the filter manu-
factures recommendations. Under-filling or over filling
the crankcase with oil can cause engine damage.
2.
Start the engine and run the engine at
“
LOW IDLE
”
for 2 minutes. Perform this procedure to ensure
that the lubrication system has oil and that the oil
filters are filled. Inspect the oil filter for oil leaks.
3.
Stop the engine and allow the oil to drain back to
the oil pan for a minimum of 10 minutes.
Illustration 79
g02173847
“
L
”
Low
“
H
”
High
4.
Remove the engine oil level gauge to check the oil
level. Maintain the oil level between the
“
L
”
and
“
H
”
marks on the engine oil level gauge. Do not fill the
crankcase above the
“
H
”
mark.
i03926370
Fan
Clearance
-
Check
There
are
different
types
of
cooling
systems.
Refer
to
the
OEM
for
information
on
clearance
for
the
fan.
Ensure
that
the
engine
is
stopped.
Ensure
that
the
battery
disconnect
switch
is
in
the
OFF
position.
Ensure
that
the
cooling
system
is
full.
The
clearance
between
the
cover
(1)
and
the
fan
(2)
will
require
checking.
The
gap
(A)
between
the
edge
of
the
cover
and
the
tip
of
the
fan
blade
must
be
checked
in
four
equally
spaced
positions.
116
SEBU8601-04