Perkins 1106 Series, User Handbook Manual, Page: 49 / 64

N40469 Chapter 5
Page 39
How to renew the canister of the
lubricating oil filter
Warning! Discard the used canister and lubricating
oil in a safe place and in accordance with local
regulations.
1. Put a tray or plastic bag under or around the filter
to retain spilt lubricating oil.
2. Remove the filter canister (figure 21 item 1) with
a strap wrench or similar tool. Ensure that the
adaptor (figure 22 item 1) is secure in the filter
head. Then discard the canister.
3. Clean the filter head.
4. Lubricate the top of the new canister seal (figure
22 item 2) with clean engine lubricating oil.
Caution:
Do not prefill with oil.
1.
Fit the new canister until the surfaces make
contact, then tighten it by hand an extra 3/4’s of a
turn only. Do not use a strap wrench.
2. Ensure that there is lubricating oil in the sump.
Operate the starter motor until the oil pressure
warning light is extinguished or there is a reading
on the gauge.
3. Operate the engine and check for leakage from
the filter. When the engine has cooled, check the
oil level on the dipstick and put more oil into the
sump, if necessary.
Caution: The canister contains a valve and special
tube to ensure that lubricating oil does not drain from
the filter. Therefore, ensure that the correct canister
is used.
Figure 21
Figure 22