2.
Start the engine and run the engine at
“
LOW IDLE
”
for two minutes. Perform this procedure in order to
ensure that the lubrication system has oil and that
the oil filters are filled. Inspect the oil filter for oil
leaks.
3.
Stop the engine and allow the oil to drain back to
the oil pan for a minimum of ten minutes.
Illustration 51
g01165836
(Y)
“
Min
”
mark.
(X)
“
Max
”
mark.
4.
Remove the engine oil level gauge in order to
check the oil level. Maintain the oil level between
the
“
MIN
”
and
“
MAX
”
marks on the engine oil level
gauge.
i02869394
Engine
Oil
and
Filter
-
Change
(CG-4
Oil)
CG-4
engine
oil
may
be
used.
If
this
grade
of
engine
oil
is
used
a
250
hour
service
interval
is
required
for
the
engine
oil
and
the
engine
oil
filter.
i02503009
Engine
Valve
Lash
-
Inspect/
Adjust
This
maintenance
is
recommended
by
Perkins
as
part
of
a
lubrication
and
preventive
maintenance
schedule
in
order
to
help
provide
maximum
engine
life.
NOTICE
Only qualified service personel should perform this
maintenance. Refer to the Service Manual or your au-
thorized Perkins dealer or your Perkins distributor for
the complete valve lash adjustment procedure.
Operation of Perkins engines with incorrect valve
lash can reduce engine efficiency, and also reduce
engine component life.
Ensure that the engine can not be started while
this maintenance is being performed. To help pre-
vent possible injury, do not use the starting motor
to turn the flywheel.
Hot engine components can cause burns. Allow
additional time for the engine to cool before
measuring/adjusting valve lash clearance.
Ensure that the engine is stopped before measuring
the valve lash. The engine valve lash can be
inspected and adjusted when the temperature of the
engine is hot or cold.
Refer to Systems Operation/Testing and Adjusting,
“Engine Valve Lash - Inspect/Adjust” for more
information.
88
SEBU8172-04