Symptom
Cause
Remedy
No Power
Blown fuse in vehicle fuse
block.
Replace fuse with same
amp rating. If the fuse
blows again, call tech
support.
No Power
Bad connection
Check cable and wiring
connection.
Alternator noise is heard
(Changes with Engine RPM)
Improper wiring creates a
ground loop
Install a Ground loop isola-
tor or seek professional
service from a local car
audio shop.
Radio is not recognizing
Audio2car interface
Bad cables or cables are
not connected properly
between converter box and
car radio
Check connection and
cables, push in firmly.
Radio is not recognizing
Audio2car interface
Wrong configuration on the
interface
Select the right pconfigu
-
ration for your car. (See
section 1.5)
Radio is not recognizing
Audio2car interface
Yellow and black wires are
not connected to Constant
12V+ and Ground. (When
applicable)
Please read wiring instruc
-
tions in chapter 2 of this
manual and see if your car
requires to connect the
yellow and black cable to
power and ground
Mobile device Audio is Low
or Distorted
Audio2car interface is con-
nected with an external CD
changer or other external
factory audio source
Disconnect the factory
external audio source.
Mobile device is not
charging
Yellow and black wires are
not connected to Constant
12V+ and Ground. (When
applicable)
Please read your vehicles
section in this manual and
see if your car requires to
connect the yellow and
black cable to power and
ground
For consumer technical support call:
866-788-4237 in the US or 727-572-9255 ext.262 for international calls
Hours: 9:30 am-6:00 pm E.S.T. MON - FRI
3.2 Trouble Shooting
15
Summary of Contents for Audio2car PXDX-KD
Page 19: ......