10
2. Run the chain below the under-seat idler and through the idler
chain guard. (Pic 20)
3. Run the chain through the next chain tube (not shown), over the
sprockets, and then down through the rear derailleur. (Pic 21)
4. Finally, run the chain through the lower tube to reach the other
end of the chain. (Pic 21)
Pic 19
Pic 20
Pic 21
Adjusting Chain Length
The proper chain length is determined by the position of the rear
derailleur.
1. Shift to the smallest cog in both the front and the rear.
2. Pull the chain taut. If the chain is too short, there will be a gap as
in. (Pic 22)
3. There should be a small gap, enough to prevent rubbing,
between the derailleur and the chain. (Pic 23)
4. Once the proper length has been determined, break the chain
using the provided tool and use the provided master link to attach
the chain.
Summary of Contents for JC26-X
Page 2: ...2...
