10
ASSEMBLY AND ADJUSTMENTS
WARNING:
Remove the grinder from the carton and examine it carefully. Do not
discard carton or any packaging material until all parts are examined.
WARNING:
To avoid injury, ALWAYS turn the tool off and disconnect the angle
grinder from the power outlet before installing or changing the grinding wheel.
INSTALLING AND REMOVING THE GRINDING WHEEL DISC
(Fig. 2)
TO INSTALL THE WHEEL DISC:
1. Unplug the angle grinder.
2. Make sure the guard (1) is
securely in place.
3. Place the inner flange (2) on
the spindle (3). Ensure that it is
located on the two flats.
4. Place the grinding wheel on the
spindle. Check the rated speed on
the grinding wheel (4).
DO NOT
use a wheel with a rated speed
lower than the speed shown on the grinder nameplate.
NOTE: The maximum wheel thickness is 6.5mm, and the center hole
dimension must be 22.3 mm.
5. Press the spindle lock button (6) to prevent movement of the spindle.
6. Keep the spindle lock button pressed in; tighten the threaded outer flange
(5) by turning it clockwise with the wrench (7).
TO REMOVE THE WHEEL DISC:
1. Unplug the angle grinder.
2. Press the spindle lock button (6).
3. Loosen the outer flange (5) by turning it counterclockwise with the wrench (7).
4. Remove the threaded outer flange.
5. Remove the grinding wheel (4) from the spindle (3).
Fig. 2
7
5
4
2
1
3
6
