20
LED WORkLIGHT
(Fig. 10)
The LED worklight, located on the
base of the Drill, will illuminate
when the trigger switch is
depressed. This provides additional
light on the surface of the workpiece
for operation in lower-light areas.
The LED worklight will turn off when
the trigger switch is released.
INSTALLING BITS
(Fig.11)
1. Lock the trigger switch by
placing the direction of rotation
selector in the OFF (center)
position.
2. Open or close the chuck jaws
to a point where the opening is
slightly larger than the bit size
you intend to use.
3. Insert a drill bit.
NOTE:
Rotate the chuck body in the
direction of the arrow marked GRIP
to close the chuck jaws. Do not use
a wrench to tighten or loosen the
chuck jaws.
4. Tighten the chuck jaws securely
on the bit.
REMOVING BITS
(Fig. 11-12)
CAUTION:
Drill bits may be hot
immediately after drilling operations.
Use gloves or wait until the bit has
cooled before touching the bit.
1. Lock the trigger switch by
placing the direction of rotation
selector in the OFF (center) position.
2. Open the chuck jaws.
NOTE:
Rotate the chuck body in the direction of the arrow marked OPEN to close
the chuck jaws. Do not use a wrench to tighten or loosen the chuck jaws.
3. Remove the drill bit.
Fig. 12
WRONG!
LED
worklight
Fig. 10
Fig. 11
OPEN (release)
GRIP (tighten)
Keyless chuck
