17
3. Pull forward on the battery pack to remove from the tool.
WARNING!
Battery tools are always in operating condition. Therefore, the
direction-of-rotation selector should always be locked when not in use or carry-
ing at your side.
NOTE:
When placing battery pack on the tool, be sure that the raised rib on the
battery pack aligns with the groove on the drill and the latches snap into place
properly. Improper assembly of the battery pack can cause damage to internal
components.
TRIGGER SWITCH
(Fig. 5a)
To turn the drill ON, depress the
trigger switch. To turn it OFF, release
the trigger switch.
VARIABLE SPEED
(Fig. 5a)
The variable-speed trigger switch
delivers higher speed with increased
trigger pressure and lower speed
with decreased trigger pressure.
DIRECTION-OF-ROTATION
SELECTOR (FORWARD/CENTER
LOCk/REVERSE)
(Fig. 5b)
The direction of bit rotation is
reversible and is controlled by a
selector located above the trigger
switch. With the drill held in normal
operating position:
1. Position the direction-of-rotation
selector to the left of the tool for
forward rotation.
2. Position the direction-of-rotation
selector to the right of the tool
for reverse rotation.
3. Setting the switch in the OFF (center lock) position helps reduce the
possibility of accidental starting when not in use.
NOTE:
To prevent gear damage, always allow the Drill to come to a complete
stop before changing the direction of rotation.
NOTE:
The Drill will not run unless the direction of rotation selector is engaged
fully to either the left or right.
Variable-speed
trigger switch
Direction-
of-rotation
selector
Fig. 5a
Fig. 5b
FORWARD REVERSE
