Performax 240-3688, Operator'S Manual

Page: 17 / 40

Page 16
ASSEMbLy
bEVEL-ANGLE INDICATOR
ADJUSTMENT (IF NECESSARy)
(FIG. 11)
1 . Unplug the saw .
2 . Check to see if the bevel-angle
indicator is pointing to 0° on the bevel
scale .
3 . If the indicator is not pointing to 0°,
loosen the bevel-angle indicator screw,
adjust the indicator to 0° on bevel-angle
scale, and then retighten the screw .
FIG. 10b
ADJUSTING THE bLADE TO THE
MITER TAbLE 45° bEVEL,
0° MITER (FIG. 12-13)
Failure to unplug your
saw could result in accidental starting
causing serious injury.
1 . Unplug the saw .
2 . Lift the bevel locking lever to release
the bevel lock (Fig . 8) .
3 . Set the bevel-angle scale to 45° . The
miter scale should be on 0° . Lower the
saw arm and push in the lock pin to lock
the saw arm in the” DOWN” position .
4 . Place a combination square on the
miter table with the rule against the table
and heel of the square against the saw
blade (Fig . 12) .
NOTICE: be sure to rest the square
against the body of the blade, and not
against the teeth of the blade.
WARNING:
FIG. 12
FIG. 11