Performax 240-3688, Operator'S Manual

Page: 15 / 40

Page 14
ASSEMbLy
5 . If the blade is not 90° to the fence,
completely unscrew the fence locking
knob and remove the fence extensions .
6 . Loosen the four hex-head bolts (Fig . 4)
and rotate the fence until the square is
flush along its entire length . Retighten
the hex-head bolts . Remount the fence
extensions .
NOTICE: If the saw has not been used
recently, verify that the blade is square to
the fence, and readjust if necessary.
MITER-ANGLE INDICATOR
ADJUSTMENT (IF NECESSARy)
(FIG. 5)
Failure to unplug your
saw could result in accidental starting
causing serious injury.
1 . Unplug the saw .
2 . Place the miter table at the zero
position, making sure the miter-detent
locking lever is secured in position .
3 . Loosen the miter-angle indicator screw
and adjust the indicator to the “0” mark
on the miter scale (Fig . 5) .
4 . Tighten the miter-angle indicator screw .
SQUARING THE bLADE TO THE
TAbLE (FIG. 6-8)
Failure to unplug your
saw could result in accidental starting
causing serious injury.
1 . Unplug the saw .
2 . Push the 0° stop pin to set the bevel
angle to 0° and lock it in place .
3 . Lower the saw arm all the way, and hold
it down while pushing the locking pin to
lock the saw arm in the “DOWN” position .
4 . Place a combination square on the
miter table with the rule against the table
and heel of the square against the saw
blade .
NOTICE: be sure to rest the square
against the body of the blade, and not
against the teeth of the blade.
FIG. 5
WARNING:
WARNING:
FIG. 6
FIG. 7
0° Stop pin