Performax 240-3600, Operator'S Manual, Page: 21 / 40

Page 20
ASSEMbLy
FIG. 19
3 . Retighten the locking knob and push
the stop pin in .
To check the angle indicator:
Loosen the locking knob and place a 90º
square against the miter gauge rod and the
miter gauge base to verify that the angle
indicator is at 0º . If it is not, loosen the
locking screw on the rod using a Phillips
screwdriver (not included) to adjust the
angle indicator to 0º, and then retighten
the locking screw .
USING THE SLIDING EXTENSION
TAbLE (FIG. 19)
Increase the length of the saw table by using
the extension table .
1 . Set the rip fence to 12 1/2” (31 .8 cm) .
2 . Push the extension-table locking lever
toward the back to unlock the lever .
3 . Slide the extension table to the desired
width .
NOTICE: Use the scale on the extension rail
when a specific width is desired .
4 . Once the extension table is set to the
desired width, re lock the lever by pulling
the lever forward .
FIG. 20
FIG. 21
ALIGNING THE bLADE TO THE
MITER GAUGE GROOVE
(FIG. 20-21)
The blade must be
square so that the wood does not bind,
resulting in kickback. Failure to do so
could result in serious personal injury.
Do not loosen any screws for this
adjustment until you have checked with
a square and made test cuts to be sure
adjustments are necessary . When the
screws are loosened, these items must be
reset .
3
1
2
4
Right Miter
Gauge Groove
Combination
square
WARNING:
Extension table