12
Assembly and adjustments (continued)
3.
Adjust the table so that the edge is a maximum of 1/16 inch from the disc. Holding the table in
this position, tighten the three bolts on the top of the table.
Note: The table may have to be re-adjusted when tilted.
WARNING:
To avoid trapping the workpiece or fingers between the table and the
sanding disc, the table edge should be adjusted to a maximum of 1/16 inch from the
sanding disc.
Mount the work support
1.
Align the Work Support with the hole.
2.
Install a Lock Washer and a Flat Washer on the Hex Screw.
3.
Insert the Hex Screw into the Work Support hole and tighten.
4.
Adjust the Work Support height to avoid contact with the sanding belt.
