25
FINISH NAIL GUN
ADJUSTING THE EXHAUST
The direction of the exhaust vent can be changed by turning
the top cover (Fig. 16).
USING THE NO-MAR TIP
If you like to protect the surface of workpiece against
scratches or markings made by the safety, attach the
accessory No-Mar Tip (F) to the safety device (A) (Fig. 17).
To replace the No-Mar Tip:
1) Disconnect the air hose from the tool.
2) Put the No-Mar Tip to the toe of the safety.
To remove the No-Mar Tip: pull the No-Mar Tip directly away
from tool.
MAINTENANCE
CLEARING A JAM FROM THE TOOL
If a nail remains jammed inside the nail gun, comply with
the following procedure:
1) Switch off the compressor.
2) Disconnect the nail gun from the compressor.
3) Remove fasteners from the tool. Failure to do so will
cause the fasteners to eject from the front of the tool.
4) Pull up on the latch (L) and open jam release (G) (Fig.
18).
5) Using caution not to bend or damage the driver blade,
using pliers or a screwdriver if required to clear the
jammed fastener.
6) Close the jam release (G) and the latch (L).
7) Reconnect the tool to the compressor as explained
in the Compressor manual at chapter “OPERATION -
USING THE AIR COMPRESSOR”.
8) Reload the tool with fasteners, as described at chapter
“Nail Loading” of this manual.
WARNING:
When attaching or detaching the No-Mar Tip, be sure to
remove your finger from the trigger and disconnect the
air hose from the nailer.
Safety (A)
Latch (L)
No-Mar Tip (F)
Jam release (G)
Fig. 18
Fig. 17
Summary of Contents for 207-9002
Page 17: ...17 REPLACEMENT PARTS LIST PARTS DIAGRAM AIR COMPRESSOR...
Page 27: ...27...
