18
‘05 - ‘06 Tacoma (W/ O.E. Hitch) - 3” Kit 5613
h.
Install kit
bracket
(rear bumper, middle) onto
O.E. trailer hitch with two kit
bolts
(1/2” x 1”),
four kit
washers
(1/2” SAE), and two kit
nuts
(1/
2” stover). DO NOT TIGHTEN.
i.
Install license plate lights on rear bumper.
j.
Install rear bumper wiring harness on frame, if
possible.
Kit
Bracket
(Rear
Bumper,
Middle)
Kit
Bolt
(1/2” x 1”),
Kit
Washers
(1/2” SAE),
Kit
Nuts
(1/2” Stover)
Rear
Bumper
License Plate
Light
Wire
Harness
Frame
k.
Install kit
tie
(zip) to rear crossmember and
bumper wiring harness.
l.
Set bumper to previous bed-to-bumper mea-
surements.
m.
TIGHTEN all rear bumper hardware.
2.
Fuel filler
a.
Mark fuel filler tubes with cut and alignment
lines.
b.
Cut fuel filler on cut lines.
c.
Deburr edges of cut tubes.
WARNING
Use extreme caution when working near the fuel lines
and the fuel tank. Clean up spilled fuel immediately. A
spark could cause an explosion or fire resulting in seri-
ous personal injury and property damage.
Kit
Tie
(Zip)
Wire
Harness
Cross-
member
Fuel Filler
Alignment
Lines
Cut Lines
Alignment
Lines
Fuel Filler
