Performance Tool W41063, Owner'S Manual

Page: 5 / 6

MAINTENANCE
1. Clean the outside of the press with dry, clean and soft cloth and periodically lubricate the joints and all moving parts
with a light oil as needed.
2. When not in use, store the press in a dry location with ram and piston fully retracted.
3. When press efficiency drops, purge the hydraulic system to eliminate any air in the system.
4. Check the hydraulic oil: remove the oil filler nut on the pump, if it is not adequate, fill with high quality hydraulic jack oil
as necessary, then replace the oil filler nut, purge away air from the hydraulic system.
BEFORE FIRST USE
OPERATING INSTRUCTIONS
1. Note: Before first use of this product, purge away air from the hydraulic system: open the release valve by turning it
counterclockwise. Pump several full strokes to eliminate any air in the system.
2. Check all parts and conditions, if there is any part broken, stop using it and contact your supplier immediately.
WARNING!
Ensure that you read, understand and apply the safety instructions and warnings before use.
1. Place the heel block on press bed frame, then insert workpiece onto the heel block.
2. Close the release valve by turning it clockwise until it is firmly closed.
3. Pump the handle until serrated saddle nears workpiece.
4. Align workpiece and ram to ensure center-loading.
5. Pump the handle to apply load onto workpiece.
6. When work is done, stop pumping the handle, slowly and carefully remove load from workpiece
by turning the release valve counterclockwise in small increments.
7. Once ram has fully retracted, remove workpiece from bed frame.
Part No. Description Qty.
1 Pressure gauge 1
2 Nylon ring 1
3 Ram assy 1
4 Lock nut M6 1
5 Serrated saddle 1
6 Upper round nut 1
7 Under plate 1
8 Under round nut 1
9 Bolt M16x35 8
10 Upper crossbeam 2
11 Nut M16 8
PARTS LIST
Part No. Description Qty.
12 Lock washer 016 8
13 Washer 016 8
14 Washer 010 14
15 Lock washer 010 14
16 Nut M10 14
17 Heel block 2
18 Press bed frame 2
19 Bed frame pin 2
20 Post 2
21 Base section 2
22 Washer 012 4
Part No. Description Qty.
23 Lock washer 012
24 Nut M12
25 Bolt M12x35
26 Lower cross menber 1
27 Bolt M10x130 4
28 Bushing 4
29 Screw M8x15 3
30
31
setting plate 1
32
Pump assy 1
33
Handle 1
34
Oil filler nut 1
35
Hydraulic hose 1
36
Connection nut 1
37
gauge connection nut 1
38
Support 4
39
Bolt M10x25 10
Hose fitting 1
4
4
4