Performance Motion Devices PR8358120, User Manual

Page: 95 / 103

Interconnect Module
Prodigy/CME PC/104 User’s Guide
95
5
The settings for the jumper (labeled JP1 in Figure 5-3 on page 94) are outlined in the following table:
5.3.3 DC-1000 Default Parameters
At power-on or after a reset, the system clock will be set to 1.1 MHz, and the default system resolution will be
determined by the settings of the DIP switches. Additional parameters are defined in the following tables:
For the DIP switches, ON = 1; OFF = 0. Default settings are all DIP switches set to OFF (0). The DIP switches are
labeled SW1 in Figure 5-3 on page 94.
5.3.4 Installing the DC-1000
The DC-1000 attaches directly to the Prodigy/CME PC/104 card, with the component sides of both cards facing each
other. The DC-1000’s parallel input socket DC1 connects to the Prodigy-PC/104 card’s Extension Connector J1 (see
Figure 4-1 on page 69).
1 To mount the DC-1000 to the Prodigy/CME PC/104 card, orient the card as shown in Figure 5-4 on
page 96.
15 +5 or +12 VDC to Encoder 3
16 Clock 3+ 3
17 Clock 3- 3
18 GND 3
19 DIN 3+ 3
20 DIN 3- 3
21 +5 or +12 VDC to Encoder 4
22 Clock 4+ 4
23 Clock 4- 4
24 GND 4
25 DIN 4+ 4
26 DIN 4- 4
Pins Jumpered Setting
1 - 2 12V DC
2 - 3 5V DC (default)
Switches (0...1) Resolution
00 10 bits
01 13 bits
10 12 bits
11 25 bits
DIP Switches Axis
1 - 2 1
3 - 4 2
5 - 6 3
7 - 8 4
These values may be overwritten by software.
IDC Pin No. Description Axis