Operation
DK58113 Developer Kit User Manual
39
2
The output driver for FaultOut is shown in
. This circuit can continuously sink over 100 mA and source
4mA from a pull-up resistor to 5V. The diode in series with the pull-up resistor allows loads powered from up to 24
VDC to be switched. The FET driver is internally protected from shorts up to 30 V.
Figure 2-15:
FaultOut
Circuit
2.10 Multi-board Synchronization
The Synch connector located on the DK58113 board (J13) allows for the synchronization of multiple DK58113
boards within a single system.
To connect two or more DK58113 boards for synchronization a cable is required. This cable is connected to the Synch
connector on the board. The Synch connector is wired in a “T” configuration as shown in
. For more
information on synchronizing multiple DK58113 cards see the
Magellan Motion Control IC User Guide.
The following diagram shows three synchronized cards.
Figure 2-16:
Synch I/O
Connector to
Three Cards
Master
Slave
Slave
J13 Synch
Connector
DK58113
Card
J13 Synch
Connector
DK58113
Card
J13 Synch
Connector
DK58113
Card
