Phone: 218.828.3700
www.nexlight.com
Fax: 218.824.1568
© 2015 NexLight Lighting Controls, All Rights Reserved.
2
Sensor Adjustments Console:
Setstheinfraredrange
Rangesetting
FullCCW=min.(OFF)
FullCW=max.
Passive Infrared Adjustment
Delayed-OFFtime
Daylight Sensor Adjustment
Factory default setting is disabled. If installed
location calls for the use of daylight sensor this is
the adjustment for control of required ambient
light levels necessary to disable the automatic
ON control of the sensor when detecting occu -
pancy. NOTE: The daylight sensor function is not
applicable in rooms using manual ON control.
All aspects of sensor operation can be adjusted here.
View of adjustments when cover is removed. Dip
Switch setting table below illustrates how to enable
and disable sensor functions.
Each time motion is detected, the lights remain
activated for a pre-set time, which is set by the
Off-time adjustment. The fully counter-clockwise
setting (30seconds) can be used for testing. If
motion is detected during the ON time, the timer
resets and lights will remain on until the full
PIR sensitivity can be dialed up or down to meet
the exact needs of any space. This adjustment is
helpful to ensure detection in all areas during a
walk test.
Setstheultrasonicrange
Rangesetting
FullCCW=min.(OFF)
FullCW=max.
Ultrasonic Adjustment
Ultrasonic sensitivity can be dialed up or down to
meet the exact needs of any space. This adjust-
ment is helpful to ensure detection in all areas
during a walk test.
SWITCHFUNCTIONS
BankAOFFON
Single Multi Tech Mode Multi Tech
Single Tech
/--
Single Tech (A1 ON)
PIR
Ultrasonic
Walk Through Mode
Walk Through Enable Walk Through Disable
---
BankB
Light Mode
L i g hts Adjust Enable
Lights Adjust Disable
LEDs Mode
LEDs Enabled
LEDs Disable
Test Mode
OFF
ON
OFF = Enter/Exit Test Mode
N/A
N/A
N/A
SWITCHSETTINGS
SWITCH
A1
A2
*
A3
A4
B1
B2
B3
B4
Multi-Tech (A1 OFF)
Multi
-
Tech mode1
Multi
-
Tech mode2
DIP SWITCH SETTINGS
N/A
N/A
N/A
