DO NOT TIGHTEN ANY SCREWS UNTIL INSTALLATION IS FINISHED.
First assembly cooling system without paste, to find out the best position for pipes but do not tighten
screws yet. Next put it on CPU allign with CPU and move pipes toward or away from radiator if
nesesary.
Apply small amount of thermal paste on CPU
and put lower plate on CPU.
Apply thermal paste on both sides of thermal
pipes (3) and install pipes 1 and 2 first. Do not
tighten any screws yet. Than install pipes 3 and
4. Do not tighten any screws.
After setting position of pipes between plates,
remove upper plate, apply small amount of
thermal paste in groves on lower plate, set
pipes, apply small amount of thermal paste on
top of pipes and put upper plate back. Now,
even you have to move pipes a little you will
have clean assembly.
P7-12
Summary of Contents for FLM-7
Page 1: ...2014...
