8
INSTALLATION INSTRUCTIONS (CONTINUED)
PREPARE THE WINDOW
1
3/4 (or 1/2 )
Screws
(7)
Lock Frame
(2)
Sash Lock
(1)
Mounting Hardware
Window sash
seal foam
(1)
PREPARE AIR CONDITIONER
2
C: Align the hole in the top rail with those in the
top of the unit as shown in Fig.B
D: Secure the top rail to the unit with the 3/8"
screws as shown in Fig.C.
NOTE
: For safety reasons, all four(4) screws
MUST be securely fastened.
INSTALL THE ACCORDION PANELS
3
NOTE:
Top rail and sliding panels at each side
are offset to provide the proper pitch to the rear
of (5/16"). This is necessary for proper
condensed water utilization and drainage. If you
are not using the side panels for any reason, this
pitch to the rear must be maintained.
A.Place unit on floor, a bench
or a table. Hold the
accordion panel in one
hand and gently pull back
the center to fill the
open end. See Fig.1.
Fig.1
Lower sash must open sufficiently to allow a clear
vertical opening of 13 inches (330 mm). Side
louvers and the rear of the AC must have clear air
space to allow enough airflow through the
condenser, for heat removal. The rear of the unit
must be outdoors, not inside a building or garage.
A: Remove the air conditioner from the carton and
place on a flat surface.
B:
Remove top rail from the rear of the packaging
material as shown in Fig. A.
Packaging
Fig. A
Top Rail
Fig.B
Fig.C
Top Rail Hardware
3/8" Screws
(4)
Top Rail
(1)
or
or
Summary of Contents for 3PNC5000
Page 1: ......
