5
LOCATION REQUIREMENTS:
IMPORTANT: Observe all governing codes and
ordinances. Check the location where the air
conditioner will be installed. Proper installation is
your responsibility. Make sure you have everything
necessary for proper installation.
• Ground electrical outlet within 4 ft. (122 cm) of
where the power cord exits the air conditioner.
• There must be free movement of air in the room to
be cooled.
• A large enough opening for the air conditioner
must exist.
• It is necessary to have adequate wall support for
the weight of the air conditioner. The unit weighs
between 70 and 85 lbs (32 go 40 kgs).
WINDOW OPENING MEASUREMENT (Fig. 2):
• 26⅞
ʺ
to 36
ʺ
(68.3 cm to 91.4 cm) opening width
• 16½
ʺ
(41.9 cm) minimum opening height
A.
26⅞ in. (68.3 cm) minimum
B.
16½ in (41.9 cm) minimum
STEP 1:
REMOVE PACKAGING MATERIAL
• Remove and dispose of or recycle packaging
materials. Remove tape and glue residue from
surfaces before installing the air conditioner. Rub a
small amount of liquid soap over the adhesive with
your fingers. Wipe with warm water and dry.
• Do not use sharp instruments, rubbing alcohol,
flammable fluids, or abrasive cleaners to remove
tape or glue. These products can damage the
surface of your air conditioner.
• Handle the air conditioner gently:
1. Remove the air conditioner from the carton and
place it on cardboard.
2. Remove shipping screw (
A
) from each side of
the cabinet. (Fig. 3)
A
3. Remove front panel by removing one Phillips
screw (
B
) from each side of the front panel. Set
screws aside and save. (Fig. 4)
B
B
4. Pull on the handle (C) to slide the air conditioner
out of the cabinet. Place the air conditioner on
cardboard. (Fig. 5)
C
NOTES:
• Handle the air conditioner gently.
• Be sure your air conditioner cabinet does not fall
out of the opening during installation or removal.
• The air conditioner should be no more than 4 ft
(122 cm) from a grounded 3 prong outlet.
• Do not block the louvers on the front panel.
• Do not block the louvers on the outside of the
air conditioner.
•
DO NOT lift, pull, or remove any expanded polystyrene
(foam) from inside of the air conditioner. It is NOT
packing material.
FIG. 1
FIG. 3
FIG. 4
FIG. 5
FIG. 2
