PMG06
PEREL
2
PMG06 – ELECTRIC DRILL AND ENGRAVING SET
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm the
environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a
specialized company for recycling. This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into service. If the device was
damaged in transit, do not install or use it and contact your dealer.
This multi-purpose electric drill is designed for drilling, grinding, sanding, polishing, brushing, engraving, cutting and
eliminating rust. Thanks to the electronic speed regulator and high-torque motor, this drill is the perfect tool for all jewellery,
precision mechanics and modelling jobs.
This electric drill comes with: 4 x collet, 6 x pointed diamond wheel, 10 x cut-off wheel, 1 x rubber polishing wheel, 2 x
sanding drum, 6 x sanding band, 10 x polishing stone, 1 x brush, 7 x polishing felt, 1 x silicon carbide grindstone, 5 x grinding
disc, 4 x mandrel, 5 x drill (1 x 0.5mm, 1 x 1mm, 1 x 2mm, 1 x 2.23mm, 1 x 2.9mm).
2. Safety Instructions
•
Damage caused by disregarding certain guidelines in this manual is not covered by the warranty and the dealer will not
accept responsibility for the ensuing defects or problems.
•
Familiarize yourself with the functions of the device before actually using it. Do not permit operation by unqualified people.
Any damage that may occur will probably be due to unprofessional use of the device.
•
Only use the device for its intended purpose.
•
Do not press the spindle lock when the device is in use.
•
Do not touch the bit during use.
•
Do not use the device if the housing is too hot.
•
Keep the work area clean.
•
Protect this device against rain and moisture.
•
Do not wear baggy clothes as the device’s moving parts may get caught in them.
•
Do not use the device in a dusty environment and near flammable liquids or substances.
•
Keep this device out of reach of children.
•
The ON/OFF switch must be off when you plug in the device.
•
Never use the device without safety goggles.
•
Store the device in a cool environment.
•
Check the device for damage prior to use and replace damaged parts if necessary.
•
Always disconnect the device from the mains when it is not in use or when you wish to clean it. Only handle the power
cord by the plug. Never pull out the plug by tugging the power cord.
•
Do not crimp the power cord and protect it against damage from sharp edges. Ask an authorised dealer to replace the
cord if necessary.
•
All accessories should be tested for at least the speed indicated on the tool label. Accessories that exceed their rated
speed can fly apart and inflict injuries.
