4
ASSEMBLY OF STOVE
Remove legs, collar and blanking plate from stove and fit in desired position. The collar
can be fitted top or rear.
The legs can be fitted at front of ash lip or rearward. To make easier for handling on
installation, remove baffle plate, side bricks, back brick and door. Place in a secure
place to avoid damage. Refit after installation.
STOVE INSTALLATION, OPERATING &
MAINTENANCE INSTRUCTIONS
IMPORTANT: THIS APPLIANCE MUST BE INSTALLED BY A COMPETENT
PERSON AND MUST COMPLY WITH NATIONAL BUILDING REGULATIONS AND
LOCAL BY
-
LAWS. UNLESS THE INSTALLER IS QUALIFIED TO APPROVE
INSTALLATION THEN APPROVAL MUST BE SOUGHT FROM YOUR LOCAL
BUILDING CONTROL DEPARTMENT. THE SUPPLIERS ACCEPT NO
RESPONSIBILITY IF THIS ADVICE IS NOT COMPLIED WITH.
THIS APPLIANCE HAS BEEN EXTENSIVELY TESTED FOR SAFETY AND
EFFICIENCY, DO NOT ATTEMPT TO MODIFY IT. ALWAYS USE GENUINE
REPLACEMENT PARTS AS RECOMMENDED BY YOUR SUPPLIER. FAILURE TO
ADHERE TO THIS ADVICE COULD INVALIDATE YOUR GUARANTEE. WHEN
OPERATING THE STOVE IN A SMOKE CONTROLLED AREA, ONLY BURN
SEASONED WOOD AND APPROPRIATE SEASONED FUELS.
HEALTH AND SAFETY PRECAUTIONS
Special care must be taken when installing the stove such that the requirements of the
Health and Safety at Work Act are met.
Handling
Adequate facilities must be available for loading, unloading and site handling.
Fire Cement
Some types of fire cement are caustic and should not be allowed to come into contact
with the skin. In case of contact wash immediately with plenty of water.
Asbestos
This stove contains no asbestos. If there is a possibility of disturbing any asbestos in
the course of installation then please seek specialist guidance and use appropriate
protective equipment.
Metal Parts
When installing or servicing this stove care should be taken to avoid the possibility of
personal injury.
15
Typical Installation Into Infilled Masonary Fireplaces
Soot Door
Seal with fireproof lagging
Max150mm
Infill
45 deg minimum