Configuring the Falcon RF
< 20 > Falcon RF WaveLAN Supplement
NET.CFG
The following code contains explanations of the con-
tents of the
NET
.
CFG
ODI configuration file for the WaveLAN wireless
LAN PC card. The
NET
.
CFG
file is suitable for use with Novell TCP/IP
and the client redirector. The
Protocol
ODIPKT
section also allows
this
NET
.
CFG
file to work correctly with an ODI–to–packet driver
shim, if one is needed for a third-party TCP/IP stack over ODI.
;Configuration settings for LSL.COM (Link Support Layer)
;
Mempool 4096
: required for Novell LSL and TCP/IP
;
Buffers 8 1500
: required to avoid "Network jammed" message
;
: in Clarkson Terminal Emulator
Link Support
MEMPOOL 4096
BUFFERS 8 1500
;Configuration for Packet Driver shim. This shim is used by third-
;party protocol stacks.
Protocol ODIPKT
BIND WVLAN43
;Configuration for TCPIP protocol.
;Substitute the appropriate IP addresses in order for your network
;to function properly.
;
IP_Address XXX.XXX.XXX.XXX
;
IP_Router XXX.XXX.XXX.XXX
;
IP_Netmask XXX.XXX.XXX.XXX
Protocol TCPIP
IP_Address 208.152.16.84
IP_Router 255.255.255.0
IP_Netmask 255.255.255.0
;Configuration Information to Install Lucent WaveLAN II drivers
Link Driver WVLAN43
;
WAVELAN_NETWORK_NAME
ANY
STATION_NAME
WAVELAN TEST 1
AP_Density
1
Transmit_Rate
3
Medium_Reservation
2345
;
Node Address
02000000cafe
Card_Power_Management
N
Maximum_Sleep_Duration
100
Receive_All_Multicasts
Y
Frame
Ethernet_II
Frame
Ethernet_802.2
Frame
Ethernet_802.3
; Configuration Information for Novell's Network Shell
;
FIRST NETWORK DRIVE
: F is standard first drive.
;
NOTE: First available drive
;
is E
;
PREFERRED SERVER
: Update for your server
NetWare DOS Requester
FIRST NETWORK DRIVE = F
PREFERRED SERVER = SERVER
NOTE:
Some of the driver-specific information is set up to work on
the Falcon, and changing these values will likely produce failures.
See “DOS Configuration Parameters,” beginning on page 21, for
more information.
