RTD-03S Waist-high rotor turnstile
15
10. Connect the cables 10, 11, 13 to the control unit (8) as follows (see Fig. 3):
•
control cable (10) to the
“Control”
connector;
•
power cable (11) to the
“DC=24V”
connector;
•
put remote control cable (13) through its cable inlet inside the control unit and connect it
to the X3 and X4 connectors on the processor module as per Fig. 9.
11. Set the CU
“Power”
toggle switch and the CU
“Battery”
toggle switch to the
“O”
position.
When connecting the indicators observe the requirements in Clause 5.4.
8.4 Electrical connection layout
Figure 9. Electrical connection layout
