10
ENGLISH
INSTALLATION:
For the correct installation of the filter it is necessary that the filter base rests completely on a clean surface that supports
the weight of the filter full of sand and water, the floor must be perfectly leveled.
Complete the valve filter connection with the appropriate kit supplied with the filter by doing the gluing operations,
taking care not to dirty the O-rings and unions with the glue, check that the six-way valve is perfectly leveled.
Make the connections provided on the six-way valve; Filter, Pump, Drain & Return.
Loading of filtration media:
CAUTION
Check that the filter has not been damaged during transport and handling before proceeding
with the filling of the filtering media.
Proceed as follows:
- Control that all the internals and filter arms are in good conditions.
- Losen the internal union and rotate the upper diffuser by 45° to
prepare for filtration media filling.
- Fill half the filter with water.
- Start filling the filtration media slowly with the quantity
mentioned on the filter label.
- Reposition the upper diffuser to the center of the filter.
- Clean the surface where the gasket sits and then put on the gasket.
- Fill the filter completely with water.
Ÿ
Proceed to close the filter using the cover, the gasket, the washers supplied with the filter
Ÿ
Check that the contact is clean and remove any dirt or residues of filterion media on the tightening bolts
Ÿ
Mount the pressure gauge on the cover in the appropriate hole (using the appropriate adaptor, lock nut and O-ring)
Ÿ
Place the lid
Ÿ
Insert the washers on the bolts
Ÿ
Place the 8 nuts and start tightening according to the sequence: 1-7-4-10-12-6-2-8-11-5-9-3 In order to guarantee a
balanced tightening of the cover.
Ÿ
The tightening must be done with a key of 13 (maximum torque equal to 14 Nm).
WARNING:
Once the operations have been completed, start the filter and check that there are no water leaks
NOTES:
The manufacturer is not responsible for any damage caused by the filtration media filling.
IMPORTANT:
The presence of the risk of flooding of premises; in the event of failure to comply with this standard, the
filter manufacturer will not be held responsible for any damage.
OPERATION:
The selector valve has a lever with 6 positions that allows you to select each of the operations necessary for correct
operation of the filter.
IMPORTANT:
always make the position valve changes with the pump off.
Filter closure:
Acqua
Water
Eau
