PePWave Surf Series User Manual
Page 21
4.5
Firmware Upgrade
The PePWave Surf is able to check whether a newer firmware (the software running on the
PePWave Surf) is available. This can be done in the Firmware Upgrade section.
However, it is recommended that you do not update the firmware unless specifically
instructed by your ISP to do so. When a firmware upgrade is needed, your ISP will either
give you instructions or upgrade the firmware remotely.
4.6
Restore to Default Settings
4.6.1 Surf Indoor Series
There are two ways to restore the PePWave Surf to default settings.
If you are able to access the web admin interface, go to the “CPE Setup” page, and click the
“Restore and Reboot” button.
Otherwise, you can also power up the unit and wait for about 1 min. Then press the Reset
button at the rear side of the unit using a pin and then hold it for 5 seconds. The unit will
restore the settings to factory default and reboot.
4.6.2 Surf DX Series
There are two ways to restore the PePWave Surf DX to default settings.
If you are able to access the web admin interface, go to the “CPE Setup” page, and click the
“Restore and Reboot” button.
Otherwise, you can also power up the Surf DX unit and wait for about 1 min. Then push the
Reset button at the bottom side of the unit and then hold it for 5 seconds. The unit will
restore the settings to factory default and reboot.
