Pepperl+Fuchs NVOR-200, Manual

Page: 9 / 52

INTERFACE
Installation
2
0
6
392
2
008
-0
1
EN - 7
EN
3 Installation
3.1 General information
Before mounting the sensor, read the chapter on "Safety," in particular the section on
"Installation and commissioning" (see chapter 1.7). Do not remove the identification plate.
During installation, read and follow the instructions of the system manufacturer and the smoke
detector manufacturer.
3.2 Mounting of the warning device
Warning!
Risk of short circuit
Injuries and damage to the device are possible when working with live parts.
• Before working on the device, always disconnect the supply voltage.
• Connect the device to the supply voltage only after completion of the work.
Note!
For further information on installing the sensor, please refer to the manuals for the sensors.
Note!
If the device is installed in a housing or switch cabinet, note the mounting instructions of the
housing or switch cabinet manufacturer.
Caution!
Overheating
If outside temperature exceeds 40 ° C with maximum load, this may result in damage to the
device.
• Ensure there is sufficient ventilation at the place of installation.
• Observe a minimum clearance of 5 mm between devices on the DIN rail.
Interface